DT 2-wire Spezifikationen PDF herunterladen (Seite 42)

System Setup

What’s User Code

In 2wire DT system, each Monitor installed in system must be programmed with a calling address or calling number,

which is User Code.

For Monitor, User Code is dened by 1~5 bits DIP switchers on the connection board, according the User Code rules.

For example, if you want to program the Monitor’s User Code to be “03”, the Monitor’s 1~5 bit DIP switcher¬s should

be set as: ON, ON, OFF, OFF, OFF(please refer to User Code table at section2Monitor).

For Door Station, each Call Button on panel is assigned to a specied User Code, and press this button will call

related Monitor. For example, press the call button labeled as “03”, system will launch a call to the Monitor which

programmed with “03” User Code.

Note

that the Bit4 of the DIP switches on the Door Station should be set to OFF

for Double line button Door Station, set to ON for Single line button Door Station.

The User Code array on panels has been predened as below, that’s the default mapping as follow:

DMR11-D8

01 02

09 10

11 12

13 14

15 16

17 18

19 20

21 22

23 24

25 26

27 28

29 30

31 32

03 04

05 06

07 08

EP11-D24

EP11-S12 EP11-S12

DMR11-S4

Bit-4=off

1 2 3 4 5 6

Bit-4=on

1 2 3 4 5 6

However, the User Code mapping of Call Buttons can be changed, so as to meet the need of complex required

installations. To program the Door Station User Code mapping, you have to use DTCONFIG software to program

each Door Station, by editing User Code, and download. Please see related contest for reference.

In another installation example, 2 Door Stations are

installed and need to be setup as below:

For example, when Call button of Guard Center and

Cancel button are needed, User Code mapping may be:

DMR11-D8

C G

03 02

05 04

07 06

Button C is defined

for Cancel operation

Button G is defined

for calling Guard Unit operation

DMR11-D8

1st door station 2nd door station

11 12

01 02

13 14

07 15

DMR11-D8

22 21

23 31

07 08

01 02

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare

DT 2-wire Spezifikationen Seite 42

Kommentare zu diesen Handbüchern