DT 2-wire Spezifikationen PDF herunterladen (Seite 10)

Door Station wiring

This example is one Door Station wiring, note that the lock used here is a 12Vdc 300mA powertounlock type.

Outlet Button

+12V

LK - (GND)

LK+(COM)

N.O.

EB+

EB -

1 2 3 4 5 6

SET

T/R -

T/R+

RS-485

JP-LK

BUS

Connect to DPS or DPS-4

Connect PC

Terminal Descriptions

1 2 3 4 5 6

+12V

T/R -

T/R+

LK - (GND)

CN-LK JP-LK

RS-485

SET

BUS

LK+(COM)

N.O.

EB+

EB -

1 2 3 4 5 6

+12V

T/R -

T/R+

LK - (GND)

CN-LK

RS-485

SET

BUS

LK+(COM)

N.O.

EB+

EB -

DMR11

Connection Board

•

+12V:

12VDC power output.

•

LK-(GND):

power ground.

•

LK+(COM):

electronical load activation relay contact common.

•

NO.:

electronical load activation relay normally open contact (the default setting for this terminal is NO, this

terminal can be configured to NC, normallyclosed contact by the DT CONFIG software). That means, by

default, only the powertounlock type of electronic lock can be connected to the COM and NO terminal, if using

the powerofftounlock type locks, the NO terminal must be set to NC contact by the DT CONFIG software.

•

EB+:

Exit button.

•

EB-:

Exit buton.

•

JP-LK:

For electronic lock safety type setting(refer to Door Station Lock Connections).

•

T/R-:

USBRS485 communication terminal negative.

•

T/R+:

USBRS485 communication terminal positive.

•

SET:

DIP switches for system congurations.

•

PA:

Press once to sent the name list to Monitor; press and hold for 3 seconds to add Master card.

•

PB:

Press once to search the Right line Monitor; press and hold for 3 seconds to search left line Monitor.

•

Bus(

L1,L2

nonpolarity bus line.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare

DT 2-wire Spezifikationen Seite 10

Kommentare zu diesen Handbüchern